I bought a development board - STM3210C-SK/RAIS [Development Boards & Kits - ARM Raisonance]. I intalled the Ride 7 from the CD in the package, set up and confirmed all jumpers then opened an example - QuickStart_STM32F107. After I clicked the Project -> Build Project command, there is an error saying that "Target power failure: Measured 0.000000V.

If I click Connect to debugger then 

My board after set up

I googled and found this website: http://www.stm32circle.com/forum/viewtopic.php?id=86 but this was using different board. It seems a bad resistor causes this problem. Does anyone can help to solve it? Thank you very much.

Zhentao Lu