|
October 14, 2010 - 2:28pm
Guest |
Dear Sir,
I have purchased Your Development Tool For ST Microcontroller from Farnell India Ltd.
Details of Tools are as under:
Name : Stx –R Link( Programmer/Debugger For St Micro )
Serial No : dndstd003013794 firmware version 0.0.3
I am facing problem and not able to program micro.
I get following message on programming:
Error resetting in ICC mode .No response from device
I am using this tool to program ST7FLITE15F1M6 microcontroller by ST. Circuit diagram of tool connection with micros are as given below.
Pl suggest remedy.
|
Hi,
There are many possible explanations for this problem. We will need more information for helping you.
Please fill this form and send the answers to :
http://forum.raisonance.com/viewtopic.php?id=2231
Best Regards,
Vincent
Problem sorted out.