Topic : Rlink in debug application doesn´t work

Forum : ST7/STM8

Original Post
Post Information Post
October 25, 2007 - 3:22pm
Guest

Hi folks!
I´m facing a weird problem with my Rlink. I can program the target chip ST72F63BK4 through it, however I can´t use it in debug mode under RIDE environment.

Once debug is started in RIDE, the following message is prompted:

Error resetting in user mode: Unable to communicate with the monitor.
Unable to start debugging c:\wil\eletronica\firmware_nobreaks\teste_fw3_ride.cos!

Any idea?

Thanks
Wilson
Replies
Post Information Post
+1
0
-1
October 25, 2007 - 6:15pm
Raisonance Support Team

Hi,

We will need more information for helping you: the Build Number of RIDE, your project, etc.
Please answer this form:
http://www.raisonance.com/Forum/punbb/viewtopic.php?id=2231

Please also note that due to the chip's design, debug is very limited with the ST72F63B devices. And your application must respect a number of "not-so-obvious" prerequisites for debug to work. Please look at the GettingStartedST7 document for more information.

Best Regards,

Vincent