Topic : Does RLink support ST72F324BK2 ? I couldn't program with it.

Forum : ST7/STM8

Original Post
Post Information Post
May 4, 2007 - 2:33am
Guest

Hello all,

I tried to connect my ST72F324BK2 target with RLink.
Even I tried to read the OPTION BYTE with the RLink,
it says

Does RLink support ST72F324BK2?
I found RBuilder doesn't support ST72F324BK2.

Best Wishes,

Byung-Tae Jung
Replies
Post Information Post
+1
0
-1
May 4, 2007 - 10:19am
Raisonance Support Team

Hi,

Yes, RLink supports the ST72F324B. I have tested it myself.

RBuilder does not support it, but RIDE and RFlasher do. Please check that you have the latest version of the software. (BN746-P1-P2-P3)

The error you get usually comes from connection problems...

Please check the USB com by reading the RLink Serial Number. (and tell it to us)

Then, please tell us which board you are using. If it's not a commercial board, we will need its schematic. (even if it's a commercial board, in fact) Please send it to "support@raisonance.com".

Best Regards,

Vincent
+1
0
-1
September 22, 2017 - 6:15pm
Philip Hirtzel

Hello all:

     We are also having problems with our ST72F324B chip.  Ours is a board we build ourselves with the ST72F324B as the controller

     I get into RFlasher7 and cannot find this chip in the list of supported.  Where can I get the profile for this chip to put into RFlasher7.  We are using  ST Visual Developer as our software development tool and we cannot get into debug because the RLink does not have a profile for the chip. 

    How is everyone else woring with this chip?

    Thanks:

     Phil Hirtzel