Forum : ST7/STM8
Original Post
| Post Information | Post |
|---|---|
|
August 24, 2007 - 2:43pm
|
When I download the HEX file to th ST7 uC it appears the uC will lock up until I disconnect the RLink from the PCB. Is there an argument to reset the uC using the ST7_pgm.exe? If not, is it possible to add this support? |
Which device do you use ? which board is the device on ?
ST72F264G2. The uC is located on one of our products. The Reset signal, Pin 6, is held low after running the .EXE. This signal also goes to other reset circuitry on the PCB which disables normal operations. I have to disconnect the RLink to allow it to release the signal. It would be nice to have a argument to allow the Reset to be released at the end of programming. Any ideas?