Topic : RLink Error

Forum : ST7/STM8

Original Post
Post Information Post
October 12, 2007 - 8:12pm
Guest

I get an error code shown below when programming a ST72F264 microcontroller on one of our products every first attempt. It will pass every time after the 1st. Any suggestions?

Error 102:
No response from the DTCError: No response from the DTC

Replies
Post Information Post
+1
0
-1
October 15, 2007 - 10:16am
Raisonance Support Team

Hi,

I will need more information for helping you. Please answer this form:
http://www.raisonance.com/Forum/punbb/viewtopic.php?id=2231

Especially, I'll need information on your clock configuration. (value of option bytes, method of entry, etc.)

I'll probably need to see the board's schematic, too.

Best Regards,

Vincent