Forum : ST7/STM8
Original Post
| Post Information | Post |
|---|---|
|
October 2, 2008 - 12:31pm
|
Hellow, We have problem when programming, the write for ST72F324K6 by RLink of ST7232x-SK. When a result of write is OK, however action of micro is irregular. We are not using daughter boards. or Is not RLink supported ST72F324K6? Best Regards, |
Hi
Even if we not make specific daughter board for the ST72F324K6 it is supported by RLink.
Do you mean that you have made your own daughter board to use it with the startrer kit?
Can you precise what do you mean by "irregular" and "the result of write is ok when the target is disconnected".
Matloub
Hellow Matloub
Thank you for your reply.
and Sorry for my information shortage.
We are not making daughter board.
We are using our target board of development product, and RLink of startrer kit.
(connect our target board and RLink of startrer kit by ICC.)
Using software:
Development by STVD.
Compiler is "Cosmic ST7".
(Base code was made by Cosmic compiler)
Programming by STVP.
Ride version is "06.10.22".
About "irregular":
When Micro is run after programming by RLink (result is OK),
Cyclical pulse is output on RESET pin.
(56ms cycle and 24.5us low pulse)
About "the result of write is ok when the target is disconnected":
1) Disconnect our board and RLink
2) Start programming.
3) Result OK is displaied.
Regards,
Hi
Thank you for the information, for this kind of problem we need a lot of precisions.
Can you fill the form you will find on the link below and send it to :
http://www.raisonance.com/Forum/punbb/viewtopic.php?id=2231
Please note we do absolutely need to have the schematic of your board.
Matloub
Hellow Matloub
I understood.
I need confirm to customer that I can send our board information (schematic, etc) to you.
When it is possible, I will send those.
Thank you for your support.
Best Regard,