Topic : ST72325K6 - Unable to install the ICP driver in RAM

Forum : ST7/STM8

Original Post
Post Information Post
August 5, 2009 - 10:54am
Guest

Dear support,
I'm using the RFlasher7 to program a custom board with ST72325K6 microcontroller. I designed my board with the DataSheet specification expecially for the ICC Interface (Figure 8, page 22, ST72325xx Datasheet).
Unfortunally when I try to program an error occours;

"Unable to install the ICP driver in RAM. Please check device selection, power and connections"

Any idea about how to solve this issue?

Best regards

Alberto
Replies
Post Information Post
+1
0
-1
August 6, 2009 - 10:08am
Guest

On the principle, it should work... as said by the messagem check first the connections. Then, a frequent issue could be around the reset management (RLink would not be able to drive the reset signal because of a conflict with a local reset supervisor ?).