Topic : Problem in using Rlink STD Device for ICC programming

Forum : ST7/STM8

Original Post
Post Information Post
February 25, 2010 - 6:31am
Guest

Hello all,

I am using a RLink-STD version 3.4 which supports for ICC and JTAG programming for ST controller family.
I am using ST7 2561J6 controller in one of my products. I am facing problem in programming the said controller using the RLink Debugging and Programing tool.
I am using a Ride7 IDE (version 7.02.001) for programming the said controller.
I have 2 Faulty and 1 OK sets of RLink STD tool with me.
Whenever I try to program the controller the message is given on the PC as
" Unable to Reset the device in ICC Mode "
I have checked the add-on board for the two faulty sets on the OK setup for ICC programming and both add-on boards are working fine.
The fault is with the RLink device(the one with Gray Enclosure). The JTAG programming is working fine though for the other two faulty RLink devices.
When connected to Ride7 IDE the connection successfully takes place and the
Serial Number and Firmware version is shown as follows

Serial Number for Faulty Device 1 : dngSTD000000157
Serial Number for Faulty Device 2 : dngSTD000001856
Firmware Version : 0.0.3 for both the devices

When checked on Oscilloscope the waveform for ICC Data was not obtained compared to the OK setup for one of the faulty devices and for the other device the ICC CLK waveform was not obtained.
I would like to know where to check for the problem on the RLink PCB (inside the Gray Enclosure of RLink Device).
Where can I get the schematic and other details for the same PCB to solve the above mentioned problems.

Thanks and regards,

Pushkar S. Patki.
Messung Systems

Replies
Post Information Post
+1
0
-1
November 8, 2010 - 3:14pm
Guest

I am also facing the same problem, but the controller is different.

Did you got the solution for it?