Topic : MISMATCH OF PID

Forum : ST7/STM8

Original Post
Post Information Post
March 1, 2010 - 1:12pm
Guest

Hi,

I'm using Rlink device connected to ST DALI Slave card and I've compiled a project whit the last version of Ride 7 but when I try to connect with target ST7DALI microcontroller to start debugging, Ride 7 open a window with message OPI Driver Error (2) and close it self.
I've ensured that target microcontroller and selection inside Ride 7 and project libraries are correct.

Thanks in advance.
Replies
Post Information Post
+1
0
-1
March 1, 2010 - 2:00pm
Raisonance Support Team

Hi,

Please tell us the versions of the Ride7 and RKit-STM8 kits that you are using. (click "help"/"About")

Please also give the complete error message. (PID read, PID expected, etc.)

Best Regards,

Vincent
+1
0
-1
March 1, 2010 - 3:56pm
Guest

Hi,

error window say:

Wrong device detectec
Mismatch of the PID
PID read: FFF
PID expected: 837

and versions:

Ride7: 7.26.09.0351
Rkit STM8: 2.26.09.317

Fermin.
+1
0
-1
March 1, 2010 - 5:28pm
Raisonance Support Team

Hi,

Thanks for the information.

Reading PID of FFF is usually the result of a hardware connection problem.

Are you using a commercial demo board? (which one?)
If not, please check that all ICC signals, including RST and VCC, are connected from RLink to the ST7, and that no "third component" can interfere in the ICC communication. (including RST) Can you send us your board's schematic?

Which version of the RLink ADP are you using and how did you set the jumpers on it? (if any)

Best Regards,

Vincent