Topic : ST7_pgm.exe

Forum : ST7/STM8

Original Post
Post Information Post
July 26, 2013 - 11:01am
Guest

Hi all.

I'm a newbie here at this Forum (and also in programming) and would like to say hello - and of course bringing in my Problem.

I want to program a ST7FMC1K4 or 1K6 device with the ST7_pgm.exe commandline tool. I'm using a RLINK Standard programmer. Everytime i start the exe it returns
Replies
Post Information Post
+1
0
-1
July 26, 2013 - 2:20pm
Raisonance Support Team

Hello,
first of all, welcome on our Raisonance Forum. We hope we can help you in your issue.
Your post has been snipped, can you post it again?
Did you set the ICC jumper?
Which adapter are you using (version)?

regards,
+1
0
-1
July 27, 2013 - 12:06am
Guest

Hello Etienne,
thanks for your cordial welcome.
Indeed my post has been snipped, so here are the clipped details:
Programmer: RLink Standard with an RLink-ADP-ST7-STM V2.1 here I've set only one jumper in the Position "ICC", the other three jumpers are in the opposite position.
At command line i typed:
st7_pgm.exe ST7FMC1K4 *.hex 0xEB1C
The response I've got was as followed:
Error 203: Product 'ST7FMC1K4' not found in ST72ICC_ProductInfo.txt.
From your reply I guess that it's basically possible to program this device with this, at least not only for me, very useful cammandline tool.

Many thanks for your efforts.
Ernst
+1
0
-1
July 29, 2013 - 3:39pm
Raisonance Support Team

Hello,

It seems that this ST7FMC devices are not supported by Ride7.
I will check if it is possible to program this STM7FMC with another device.

best regards,
+1
0
-1
August 6, 2013 - 4:35pm
Raisonance Support Team

Hi,
All ST7 are supported by the Rlink (debugger) but this device (ST7FMC1K4) is not supported by Ride7.
To program this MCU you should use the ST software like STVP, STVD.
Best regards,