June 26, 2014 - 9:23pm
Guest |
hello,
I have a problem debugging with Raisonance RLink.
I'm using a microcontroller ST72F321R9 and after transforming the program from cosmic to Raisonance, I can not debug:
The file is compiled without errors and is loaded correctly with the command "START", but does not allow me to place the break point and after RUN and PAUSE command, two windows open with the following error codes: 1645 and 2750.
Premise that the signals "ICCDATA" and "ICCCLK" are used only by the emulator and ports of the micro are set as inputs.
If use ST7 Simulator, I can debug functions regularly, including the insertion of the break point.
thanks
|
Hello, Could you confirm us that you have installed the latest version of Ride7 and the Rkit-STM8. Could you provide us your serial number. Regarding your issue, ST7 devices with HDFlash and no debug module can be programmed, but debugging through ICC is very limited with them. (See Section 6.6.9 from getting started ST7/STM8[/url] Limitations for ST7 HDFlash targets without debug module for more information). Please have a look of all the section 6 of the getting started. Could you send us the entire error message? I hope it helps. Regards,