Topic : STR7-EVAL (MB393B STR710FZ2) Flash Programming

Forum : ARM

Original Post
Post Information Post
August 3, 2007 - 6:33pm
Guest

I'm trying to program STR7-EVAL with RFLASHER but with no luck. Could anyone provide advice on the topic? What is the correct jumper and switches configuration. Also I couldn't find any ready made software in hex or bin to try it out. Is the default software available in these formats or just in axf.

Thanks
Replies
Post Information Post
+1
0
-1
August 6, 2007 - 8:56am
Guest

Hello,

I suggest you to look at this FAQ. If it still does not work, please fill in this form and send me your answers to .

regards
Lionel
+1
0
-1
August 7, 2007 - 8:19am
Guest

Thanks for your reply. I am indeed having problem with the STR710. How will I know for sure that I have RLink-STD?
Will the cut of the pin have any side-effects? Will it affect the jumpers - switches setting?
+1
0
-1
August 7, 2007 - 9:12am
Guest

The cut of the pin has no side-effect. The adapter can then be used safely for any STRx device supported. If you have the adapter shown on the picture of the FAQ, it means that you use a RLink-STD or a RLink-PRO. In both cases the FAQ applies and the pin must be cut.

regards
Lionel