|
April 2, 2008 - 2:11pm
Guest |
Hi everybody,
I have the starter Kit REva for the STM32. I have on this board the embedded Rlink v3.3 and i want to use it for dowloading and debugging program on my new STM3210B-eval board from ST.
Can i do do this ?
I have to make my own interface between the 24 pin JTAG connector of the Raisonance evaluation board and the 20 pin JTAG connector of my new STM3210B-eval board...
I have to move some jumpers on the evaluation card from raisonance ?
Thank you, and if someone already did this, tell me ! I will be glad to know if it's working fine or not .
Thank you very much.
|
Hi
Concerning your issue about the jumpers of the mother board you do not need to change them.
You only have to make sure that there is no daughter board fixed on it.
You can also take off the VCC jumpers of the motherboard to be sure the embedded RLink does not see it.
bye
Thank you Matloub ;)
Hi,
Yes, we have already done it. You'll find the information you need there:
http://www.raisonance.com/Forum/punbb/viewtopic.php?id=2449
As Matloub said, don't forget to remove the daughterboard when doing this, or there is a risk of electrical conflict. (smoke!) The jumpers will have no impact. You can leave them as they are.
Best Regards,
Vincent
Thank you VincentC :)