Topic : Can i use the rlink with atmel at91sam9263 (ARM9) processor?

Forum : ARM

Original Post
Post Information Post
March 30, 2009 - 12:08pm
Guest

Hi, i was trying to connect the Rlink-STD to the board with atmel at91sam9263 processor. I use the openOCD, it has rlink support. But it can not work. And i have same qestions:
1. Can the Rlink-STD debug the ARM9 processors?
2. How the minimal TCK clock for Rlink? I think this is the my problem. Because sam9263 processor will start at low frequency. And it need the low JTAG clock(about 4kHz) at first time.

My board http://www.ronetix.at/starter_kit_9263.html
Downliad link for openOCD for win http://prdownload.berlios.de/openocd/openocd-0.1.0.msi

All software run under Win XP.
P.S. Sorry for my english
Replies
Post Information Post
+1
0
-1
April 10, 2009 - 4:50pm
Guest

Hi

I am afraid this chip is not supported by RLink.

We are making effort to support more ARM targets, so in the last release of our
software Ride7 and RKit-ARm from April ,
the ARM7 from NXP are now supported by RLink .

I hope we can implemnt targets from ATMEL in the future.

Regards,
Matloub