Topic : CAN interface problem

Forum : ARM

Original Post
Post Information Post
January 26, 2010 - 7:36pm
Guest

Hi,

I'm trying to create a interface between two arm9 str912f starter kits using CAN protocol. On the loop back test mode the project seems to work but when i connect the two kits, the receiver uC does not call the CAN interrupt.

Using the Oscilloscope, we can see both receiver and transceiver work.
Can you give some samples about can protocol, cause i can't find no one.

Best Regards.
Replies
Post Information Post
+1
0
-1
January 27, 2010 - 4:28pm
Guest

Hi

Sorry but Raisonance does not provide advanced example code source.
You might find more source in ST librairies or from their support team.

Regards
Matloub