Forum : Ride IDE
Post Information | Post |
---|---|
September 25, 2008 - 10:05am
|
Hi Vincent, So far it was working fine & suddenly started giving message like "Error During Connection to target", "Unable To Read ID code". Connect to RLink is fine & showing "dngStd004000564". I have 3 boards ready & all are giving same error. Then I monitored all JTAG pins on RLink's 20 pin box header. All were absent. When Reset button is held down , I could see pulses on all signals except JTag's Reset pin. I opened the Dongle & checked for pulses on this board. JRst is absent here!! What to do now? Can I send it to your place for inspection? I bought it from DigiKey(with the help of my brother in USA). Please HELP!!! |
Please follow this topic from here:
http://www.raisonance.com/Forum/punbb/viewtopic.php?id=2595