Topic : Rflasher to program STM8 with Rlink

Forum : ST7/STM8

Original Post
Post Information Post
October 26, 2016 - 7:36am
Artur Butryn

Hello, purchased Rlink programmer but it came without any programming/debuggging software. Paid around 100 EUR so I thought at least standard functionality(up to 64k) should be provided based on this price but unfortunately it's not the case.

Cannot download RFlasher from anywhere on raisonance site because it seems they stopped providing it.

Should I just  junk Rlink and go for ST-LINK/V2 to program STM8 or there is a way to do it with Rlink?
Replies
Post Information Post
+1
0
-1
October 26, 2016 - 10:56am
Etienne Cassin

Hello,

Rlink-STD basic license for STM8 devices allows programming and debugging in unlimited version, only the compilation is limited to 2k.

Concerning Rflasher, this software belong to our Ride7 IDE.

Please, install Ride7 and Rkit-STM8 from the following link (Rflasher will be also installed):

http://support.raisonance.com/content/ride

http://support.raisonance.com/content/rkit-arm

I hope it helps.

Best regards,
+1
0
-1
October 26, 2016 - 2:12pm
Artur Butryn

Thank you for the response. Found the Rflasher, seems to work ok.
+1
0
-1
October 27, 2016 - 3:25pm
Etienne Cassin

Thank you for the feedback

best regards,
+1
0
-1
March 31, 2017 - 11:40am
Bert Boudewijns

I have bought a Rlink but did not receive the basic license. How does it work?

Oke found it. A small information in the manual would have been nice