Topic : Opening RFlasher7 and loading software automatically

Forum : ARM

Original Post
Post Information Post
August 11, 2017 - 1:10pm
Simon Newton

Hi All

Is there a way to open the RFlasher7 program and have the correct software loaded just by selecting the relevant HEX file? If I click on the .rpri file I get the error message “ This is not a Ride7 project. Please open this with RFlasher7”

The only difference I can see between Ride7 and RFlasher7 programs is “-mRFlasher7” at the end of the target shortcut.

Regards

Simon
Replies
Post Information Post
+1
-1
-1
September 11, 2017 - 11:58am
Anil Kumar

Hi,

Can anyone please help me on downloading the RFlasher7 setup( Path) to install in my PC and then start programming using R-Link. thanks in advance

regards,

Anil Kumar. B
+1
0
-1
July 29, 2021 - 6:55am
Jose Edwin Patricio

You may use the cortex_pgm command line